![]() ![]() To avoid interoperability issues and to achieve tunnel redundancy with a single CPE ConfigurationĬisco ASA: Policy Based: Oracle recommends using a route-based configuration Maximum Transmission Unit (MTU): The standard internet MTU size is 1500 bytes.įor more information on how to determine your MTU please see Overview of MTU. ![]() For instructions, seeĬhanging the CPE IKE Identifier That Oracle Uses. Oracle expects the value to be either an IP address or a fully Provide the value either when you set up the IPSec connection, or later, by editing If you cannot, you must change the remote IKE ID in the Oracle Console to match your CPE's local IKE ID. Local IKE identifier: Some CPE platforms do not allow you to change the local If you want one IPSec connection as primary and another one as backup, configure more-specific routes for the primary connection and less-specific routes (or the default route of 0.0.0.0/0) on the backup connection. If both IPSec connections have only a default route (0.0.0.0/0) configured, traffic will route to either of those connections because Oracle uses asymmetric routing. Multiple IPSEC Connections: You can use two IPSec connections for redundancy. "IP SLA Configuration" in the Cisco ASA policy-based configuration template. For more information, see the section for Traffic running through the IPSec tunnels. CertainĬisco ASA versions require the SLA monitor to be configured, which keeps interesting Through the IPSec tunnels at all times if your CPE supports it. Times: In general, Oracle recommends having interesting traffic running
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |